Free Shipping on all orders in the U.S.

OOber Tactical Praetorian series shotgun instructions of applying VELCRO to side receiver

How to apply OOber Tactical Praetorian Series Side Saddles

Attaching VELCRO® to your shotgun

Always insure firearm is unloaded and cleared before performing any work.

1.  Inspect the 12 gauge shotgun or a 20 gauge shotgun receiver, buttstock etc, where the Adhesive Industrial Strength VELCRO® Loop fastener to be attached.  

Be sure it is clean, free of any grease or oil and dry.  

Match the VELCRO®  Loop to where it is to be attached i.e. the side of the receiver of a shotgun.  (Extra VELCRO® Loop can be attached to many different surfaces such as vehicle interiors, clothing and even in discreet areas within the household, anywhere accessibility is needed when deploying your shotgun. 

An extra Ammunition Carrier can be slapped to your receiver.) 

Be sure to trim or cut any access points on your shotgun such as pins or screws so the VELCRO® Loop does not cover over them for future cleaning and maintenance.  (see picture above as example)

2.  Peel the Adhesion tape off the back of the VELCRO® Loop and place down matching any pre cut holes for screws and pins.  

Begin to press out evenly making sure the adhesive makes good contact with the surface.  

Allow a full 24 hours to cure before use. 

3.  When fully cured take the ammunition carrier and put it on the VELCRO® Loop and push then pull it a few times.  This will activate the loop by bringing it up and giving greater retention capabilities. 

4.  Remember to inspect the loop for wear and replace when necessary. To remove, be sure firearm is unloaded. Secure firearm as not to move. Begin at a corner edge to peel. A blow dryer on hot setting may help the process. Begin peeling with a smooth pull. It will have a strong adhesion. Keep constant pull using mild heat to help. Once removed, adhesive residue on reciever can be removed by using an adhesive remover such as "Goo Gone" type product. Wipe clean, then reapply a new VELCRO® Loop strip starting at 1 at the top of these instructions.

5.  Check the VELCRO® hook side on the carrier for debris.  

Clean with a nylon bush/toothbrush to remove dirt and sand if necessary to keep retention performance.

Learn More

Watch our YouTube videos for OOber Tactical Praetorian Shotgun Side Saddles.

Find out more

Home Invasion "How to Protect Yourself" Shotgun Side Saddle Instructions

Simple and effective knowledge base for critical dynamic home invasion situations.